• On completion of this topic you should be able to: • demonstrate an understanding of fibre diameter and the economic importance of fibre diameter • explain and calculate the difference between the standard deviation of diameter and the coefficient of variation of diameter • define the relationship between mean diameter, diameter variation and “coarse edge” or “prickle” • measure staple strength and describe its economic importance • explain the sources of variation in staple strength within a mob of sheep • describe localised vs generalised fibre weakness as determinants of staple strength • define and quantify the relationship between staple strength and each of minimum diameter, along-staple diameter variation, rate of change in diameter, fibre length variation and intrinsic fibre strength • relate raw wool style including the main component traits to economic importance • explain the influence of fibre diameter and fibre crimp on wool handle • describe fibre curvature and the value of curvature more »
  • The Optical Fibre Diameter Analyser 2000 (OFDA2000) model allows coefficient of variation of fibre diameter (CVFD) to be separated into a between fibre diameter variation component and an along fibre diameter variation component. Both traits are heritable (0.4 and 0.20, respectively) but not as heritable as CVFD on a minicored sample (0.67). Only CVFD between fibres is genetically strongly (-0.7) correlated with SS to nearly the same extend as CVFD (-0.65). It is more effective to use CVFD of wool samples as an indirect selection criterion to improve SS. In addition this will also result in a reduction in the propensity of FD to blowout along the staple. Keywords: Genetic parameters, fibre diameter variation, staple strength, micron blowout. more »
  • Fibre diameter can vary dramatically along a wool staple, especially in the Mediterranean environment of southern Australia with its dry summers and abundance of green feed in spring. Other research results have shown a very low phenotypic correlation between fibre diameter grown between seasons. Many breeders use short staples to measure fibre diameter for breeding purposes and also to promote animals for sale. The effectiveness of this practice is determined by the relative response to selection by measuring fibre traits on a full 12 months wool staple as compared to measuring them only on part of a staple. If a high genetic correlation exists between the part record and the full record, then using part records may be acceptable to identify genetically superior animals. No information is available on the effectiveness of part records. This paper investigated whether wool growth and fibre diameter traits of Merino wool grown at different times of the year in a Mediterranean environment, are genetically the same trait, respectively. The work was carried out on about 7 dyebanded wool sections/animal.year, on ewes from weaning to hogget age, in the Katanning Merino resource flocks over 6 years. Relative clean wool growth of the different sections had very low heritability estimates of less than 0.10, and they were phenotypically and genetically poorly correlated with 6 or 12 months wool growth. This indicates that part record measurement of clean wool growth of these sections will be ineffective as indirect selection criteria to improve wool growth genetically. Staple length growth as measured by the length between dyebands, would be more effective with heritability estimates of between 0.20 and 0.30. However, these measurements were shown to have a low genetic correlation with wool grown for 12 months which implies that these staple length measurements would only be half as efficient as the wool weight for 6 or 12 months to improve total clean wool weight. Heritability estimates of fibre diameter, coefficient of variation of fibre diameter and fibre curvature were relatively high and were genetically and phenotypically highly correlated across sections. High positive phenotypic and genetic correlations were also found between fibre diameter, coefficient of variation of fibre diameter and fibre curvature of the different sections and similar measurements for wool grown over 6 or 12 months. Coefficient of variation of fibre diameter of the sections also had a moderate negative phenotypic and genetic correlation with staple strength of wool staples grown over 6 months indicating that coefficient of variation of fibre diameter of any section would be as good an indirect selection criterion to improve stable strength as coefficient of variation of fibre diameter for wool grown over 6 or 12 months. The results indicate that fibre diameter, coefficient of variation of fibre diameter and fibre curvature of wool grown over short periods of time have virtually the same heritability as that of wool grown over 12 months, and that the genetic correlation between fibre diameter, coefficient of variation of fibre diameter and fibre curvature on part and on full records is very high (rg > 0.85). This indicates that fibre diameter, coefficient of variation of fibre diameter and fibre curvature on part records can be used as selection criteria to improve these traits. However, part records of greasy and clean wool growth would be much less efficient than fleece weight for wool grown over 6 or 12 months because of the low heritability of part records and the low genetic correlation between these traits on part records and on wool grown for 12 months. more »
  • What is SD? SD stands for Standard Deviation. Standard deviation is a statistic which measures the degree of variation of fibre fineness above and below the average fibre diameter. The higher the SD, the more variable is the fleece sample. more »
  • Heritability was estimated for a range of visually assessed traits recorded on Merino sheep, together with the phenotypic and genetic correlations among the visually assessed traits and correlations of the visually assessed traits with measured wool production traits and liveweight. Data were derived from four research resource flocks, with a range of 12 958 to 57 128 records from animals with 478 to 1491 sires for the various traits. The estimates of heritability were high for the wool quality traits of handle, wool character and wool colour (0.33–0.34) and the conformation traits of face cover, neck wrinkle and body wrinkle (0.42–0.45), moderate for front leg structure (0.18) and low for back leg structure (0.13). Fleece rot score had low heritability (0.14), while classer grade was moderately heritable (0.20). Estimates of genetic correlations among the visually assessed wool quality traits were low to moderate in size and positive (0.17–0.47). Genetic correlation estimates among the assessed conformation traits were generally very low, except for the genetic correlations between scores for neck and body wrinkle (0.92 ± 0.01) and front and back leg structure (0.31 ± 0.09). Fleece rot score had low positive genetic correlations with neck and body wrinkle scores (0.18 ± 0.05 and 0.15 ± 0.05, respectively) and classer grade (0.26 ± 0.06). Classer grade was slightly positively correlated with the wool quality traits (0.17–0.45) and leg structure traits (0.21–0.25). The genetic correlations among the visually assessed traits were generally neutral to favourable. The visually assessed wool quality traits had low to moderate favourable genetic correlations with mean and coefficient of variation of fibre diameter (0.19 –0.47), but negative correlations with clean wool yield (–0.26 to –0.37). Face cover was unfavourably correlated with staple length (–0.27 ± 0.04) and liveweight (–0.23 ± 0.02). Neck and body wrinkle scores were genetically associated with higher greasy (0.33–0.39) and clean fleece weights (0.19–0.22), greater coefficient of variation of fibre diameter (0.24–0.26) and fibre curvature (0.27–0.28), but with reduced yield (–0.26 to –0.28) and staple length (–0.34 to –0.41). Fleece rot score was genetically correlated with clean fleece weight (0.26 ± 0.05) and coefficient of variation of fibre diameter (0.27 ± 0.04). Classer grade was favourably correlated with greasy and clean fleece weights (–0.41 to –0.43), staple length (–0.29 ± 0.04), liveweight (–0.36 ± 0.03) and coefficient of variation of fibre diameter (0.27 ± 0.03). Most genetic correlations between the visually assessed traits and the measured production traits and liveweight were close to zero and less than 0.2 in magnitude. This study provides accurate values for the parameter matrix required to incorporate visually assessed traits into breeding objectives and the genetic evaluation programs used in the Australian sheep industry, allowing the development of breeding objectives and indexes that optimally combine visually assessed performance and measured production in Merino sheep. more »

ContactHelp